Husqvarna Viking 412627045 6 mm cord foot

6 mm cord foot

Apply the presser foot to easily, quickly and accurately make and insert profiled cords into your upholstery and interior decoration work.
This accessory foot ensures professional finishes with both the pre-packaged profile and made by you.
It sews like the cording foot, but is suitable for large cords.

To cover the cord:

• Use a 6mm cotton cord. Cut strips on the bias or reverse thread, wide enough to cover the drawstring and sewing allowance.
  
  
• Attach the cording foot to 6 mm. Select the straight stitch with the needle in the center, length 3.
  
  
• Place the drawstring on the wrong side of the fabric strip and wrap the fabric around the drawstring.
  
  
• Place fabric and drawstring under the 6mm drawstring foot with the drawstring in the groove on the bottom of the presser foot.
  
  
• Sew to cover the cord with the fabric.

To insert the covered cord directly into a seam:

• Attach the 6 mm drawstring foot. Select the straight stitch with the needle in the center, length 3.
  
  
• Place the covered drawstring on the right side of the fabric along the seam. Place it under the 6mm drawstring foot with the drawstring at the hem in the groove of the presser foot. Sew the cord to the fabric. Cut the seam allowance along the curves and corners of the seam.
  
  
• Place the second piece of fabric on top keeping the two right sides together. The profile will be located between the two layers. Place the profile in the groove and sew keeping the first row of stitches at the top. Adjust the width to move the needle slightly to the right to cover the first seam.